The anthurium plant is developed as a houseplant in cooler territories and as an landscaping plants in USDA zones 10 or higher. Appropriate consideration for anthurium is anything but difficult to do as long as you give a couple of key components to the plant. Anthurium plants can endure all degrees of roundabout light, yet anthuriums filling in low light will have less blossoms and will develop more slow. These plants can’t endure direct light notwithstanding, as this can consume the leaves. They fill best in brilliant, aberrant light. Anthurium care likewise necessitates that the dirt be free depleting yet hold some water. On the off chance that you are developing this plant as a houseplant, a cream blend of fertilized soil and orchid soil or perlite will give the sort of soil anthuriums like. Outside, plant in a very much depleted area. Anthurium plants don’t care for consistently damp soil.Make sure to water your anthurium plant routinely, yet don’t over water. Possibly water your anthurium when the dirt is dry to the touch. The plant is helpless to root decay, so an excessive amount of water can make the roots kick the bucket. In the event that you permit the plant to turn out to be too dry in a pot, it will hinder its development and the rootball will be hard to re-wet. In the event that the rootball turns out to be too dry in the pot, splash the pot the anthurium plant is in for an hour to rehydrate it. In this article I will talk about fertilizers which are utilized for anthurium fertilization.
There are two types of fertilizers which can be used to fertilize an anthurium: slow release or liquid. With slow release, you apply it once and don’t have to apply it again for six months. With liquid fertilizer, you will have to apply it every week. In general, I recommend using slow release fertilizer unless you are willing to devote a lot of attention to your plant.
Also Read: Ways Our Water Supply Can Be Protected
The main thing to look for in a fertilizer is an even ratio of nitrogen, phosphorus and potassium. To find this type of fertilizer, just look at the numbers on the bottle. They should be something like 15-30-15.
Once you have selected a fertilizer, you will need to apply it. To apply it just read the directions on the label and reduce the amounts you see there by 75%. Let’s say that the label says that for 8 inch pots you should apply 1 teaspoon, for an anthurium in an 8 inch pot you should instead apply a quarter teaspoon. As far as application frequency, a slow release fertilizer should be applied once every six months.